Hi,
I am conducting some experiments with photogrammetry and would like to use digiCamControl.
The setup consist of 1 to 3 DSLR's (which is working fine with dCC) and a turntable connected via serial port (a DAVID TT-1 borrowed from my structure light scanner).
The sequence would be quite simple: capture -> turn 10° -> capture -> turn 10° -> ...
Is there a simple way to send commands (something like "move 10\CR" to a serial port, e.g. via scripting?
Thanks in advance for your help
Kai
Using digiCamControl for Photogrammetry: Controlling Turntable
-
- Posts: 2
- Joined: Thu Nov 23, 2017 4:59 pm
-
- Posts: 2
- Joined: Thu Nov 23, 2017 4:59 pm
Re: Using digiCamControl for Photogrammetry: Controlling Turntable
...found a solution:
I wrote small .Net program controlling the turntable via serial port and dCC via the "CameraControlRemoteCmd".
I must say that dCC works like a charm!
P.S.: Will donate...
I wrote small .Net program controlling the turntable via serial port and dCC via the "CameraControlRemoteCmd".
I must say that dCC works like a charm!
P.S.: Will donate...