When doing long series sometimes two pictures are captured while only one is needed

General Discussion about digiCamControl and related photography techniques.
Post Reply
Andrzej
Posts: 1
Joined: Mon Oct 01, 2018 5:01 pm

When doing long series sometimes two pictures are captured while only one is needed

Post by Andrzej » Mon Oct 01, 2018 5:13 pm

Hello,

I am not an advanced photographer at all, I just need to take long series of documents. I discovered Digicamcontrol, because I had no sucess with installing the Nikoncamera control on a new laptop (worked on the oldlaptop) Digicamcontrol worked immediately :P . It works fine but from time to time it's taking two photos at once while I just want one.

I understand I can take photos with Live View or with the camera program? I do with Live View. I put a shortcut on "Capture". Several photos are taken correctly, and then suddenly I got two pictures of the same object, no idea why and no idea where I could configure that.

Thanks in advance for help!

Andrzej

When doing long series sometimes two pictures are captured while only one is needed

Advertisment
 

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests