Can not install set up at all

Support and help for digiCamControl (no bug report)
Post Reply
TN GUY
Posts: 1
Joined: Fri Jan 25, 2019 12:48 am

Can not install set up at all

Post by TN GUY » Fri Jan 25, 2019 12:56 am

I have tried to install the 2.1 Digi Control and it keeps saying I need to uninstall a previous version. There is nothing in the control panel even remotely close to aa previous Digi Cam Cntrol and I did a very deep file search also finding nothing. I have attached the file error codes. It just keeps saying I need to uninstall which there is nothing to uninstall anywhere. Any ideas? I check thee Microsoft frame work and it is up to date. I have rebooted the computer twice, ran a file reg clean. and I can't still run set-up. I give up. You would think it would just load over a previous version or re-install or remove old files and install. Never had a issue like this.
Attachments
ne notepad.txt
(2.46 KiB) Downloaded 38 times

Can not install set up at all

Advertisment
 

Post Reply