Hi,
Just a quick question. I am using Canon 77D. I notice there is a 1-2 second pause after each capture before I could take another shot. However, with EOS Utility, I could take shots much quicker, with minimal pause between shots.
My PC uses super fast NVME SSD, so I don't think it is due to disk writing.
I love DigiCamControl as it is so much more versatile than EOS Utility. I hope there is a way to increase the capture speed.
Thanks again.
Burst capture of Canon 77D
Re: Burst capture of Canon 77D
Update: My workflow currently uses the Remote Utility to trigger capture as defined below:
http://www.digicamcontrol.com/doc/userguide/remoteutil
The command I am using is: CameraControlRemoteCmd.exe /c capture
Everything is working perfectly, except for the "pause" or "freeze" between shots.
It seems like Digi Cam Control Software requires several seconds to "process" each photo transferred to PC before the Remote Utility could perform the next capture.
Is there anyway that would allow me to capture at around 1/2 second interval with the Remove Utility (or any other methods without using a physical remote or touching the camera)?
Your help would be greatly appreciated
http://www.digicamcontrol.com/doc/userguide/remoteutil
The command I am using is: CameraControlRemoteCmd.exe /c capture
Everything is working perfectly, except for the "pause" or "freeze" between shots.
It seems like Digi Cam Control Software requires several seconds to "process" each photo transferred to PC before the Remote Utility could perform the next capture.
Is there anyway that would allow me to capture at around 1/2 second interval with the Remove Utility (or any other methods without using a physical remote or touching the camera)?
Your help would be greatly appreciated