LV stopped working with D810

[Smudger308]

Hi there, I have a Nikon D810 remotely mounted and connected via a usb to ethernet converter. It has intermediate software that creates a virtual IP address. dCC has worked really well but for some reason it no longer works. I get the Invalid Start message and have to shut the software down. I have tried rebooting the software but this doesn't work either.

Any thoughts on why this has suddenly happened?

Paul

[Duka Istvan]

From nikon documentation for invalid status error :
An error caused by the camera (battery empty, warning information) occurs, or the shutter-release button is being fully pressed.

[Smudger308]

Thanks Duka. The camera is mounted in a gyro stabilised turret on an aircraft so I will need to determine if there are any connection issues etc to do with the firing of the shutter. Is there a possibility that a rogue signal could be coming from your software or is it more likely the camera itself?

[sonumanwal]

We faced the same issue, the reason for my problem was we removed the memory card, after inserting the memory card again it worked perfectly.