Users from old forum should register again, the old credentials no longer are valid

DCC and D800 live view zoom

Report bugs and errors to the digiCamControl development team.
Post Reply
johnplush
Posts: 1
Joined: Fri Apr 28, 2017 7:17 pm

DCC and D800 live view zoom

Post by johnplush » Fri Apr 28, 2017 7:30 pm

When choosing a focus area in Live View (by positioning the green rectangle over the bit to focus on), the program selects a spot way off to the left and higher than the position chosen. I have tested this effect and concluded that when it reads where the green rectangle is, it is doing so with reference to a frame exactly 1/4 of the frame actually shown on screen. So if I select the bottom right-hand corner as the focus point, the program instead focusses on a point dead centre of the displayed image. If I choose a point at the bottom-centre of the displayed image it focusses on a point half-way-up the displayed image, and one-quarter of the width to the left of centre. It is thus impossible to focus on a point anywhere to the right of or below the centre of the image displayed from my Nikon D800!
Is this usual? Is there a work-around? Thanks.

DCC and D800 live view zoom

Advertisment
 

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest