digiCamControl

Unlike Nikon, Canon's default Transfer mode seems to be [1.Save to PC only]??

If I change it to [3. Save to PC and camera], of course it does work well.
But I turn off and again turn on Canon...it eventually returns to [1. Save to PC only]

https://youtu.be/97KYoG5ZrTA

How can I save Canon Transfer mode to [3. Save to PC and camera] ??
Thanks in advance.

[PS] Option check [File->Settings->Advanced->Load Canon transfer mode] is NOT solution in this case.

Which version of the application do you use ?

It is ver. 2.0.74

Nikon remembers the last used transfer option 1 or option 3.
However, for Canon, the transfer option always returns to 1. when I turn the power back on.

I hope Canon will be the same way as Nikon.

Oh~~It works perfectly in version 2.0.72.
Thank you.

hi, im just starting to use digicamcontrol and loving it!. but i also have the same issue, using last beta version (.79) with a canon 80D, is goes to "PC only" after reconnecting the camera.

using the older version as mentioned (2.0.72) the setting is saved correctly after reconnecting.

thanks!

You have a option for this File=>Settings=>Advanced=>Load canon transfer mode

Hi~~Duka
Checking the option "Load Canon transfer mode" does work normal ONLY in Ver 2.0.72