Beta 1.2.89 Not starting with 4 x Canon 100D Cameras

simon.s.holden · Post by **simon.s.holden** » Fri May 15, 2015 3:26 am

Just tested 1.2.89, locking up on startup, app log attached. (Unintstalled, and reinstalled), running back on previous working version. 1.2.71.0

Beta 1.2.89 Not starting with 4 x Canon 100D Cameras **Advertisment** Top

Beta 1.2.89 Not starting with 4 x Canon 100D Cameras

Duka Istvan · Post by **Duka Istvan** » Fri May 15, 2015 11:45 pm

Hi, please check this version: https://s3.amazonaws.com/download.digic ... 2.96.0.msi

simon.s.holden · Post by **simon.s.holden** » Thu May 28, 2015 1:13 am

Still having issues starting up, did a completely clean install of the software. Here is the log file:

simon.s.holden · Post by **simon.s.holden** » Thu May 28, 2015 1:41 am

Have rolled back to 1.2.78.0, which is starting fine. App log attached has the two latest versions starting up, and then the working version. Versions not working: 1.2.97.0 and 1.2.96.0I removed the branding file from the folder, as though that might have made a difference, but didn't. Have attached that here as well.

Duka Istvan · Post by **Duka Istvan** » Sat Jun 06, 2015 10:02 am

Hi, try this version https://s3.amazonaws.com/download.digic ... msiUncheck in settings->Advanced->Load Canon Transfermode, the iso problem should be solved

simon.s.holden · Post by **simon.s.holden** » Tue Jun 09, 2015 7:26 am

Cool, that works, but I have to unplug the cameras from the computer, start digicam control, then uncheck the Load Canon Transfermode box, and then plug the cameras in, everything works fine except the program isn't exiting fully when closed. You have to manually go into task manager and kill it if you want it to fullly shut down. Do you need the log file again?

simon.s.holden · Post by **simon.s.holden** » Tue Jun 09, 2015 11:36 am

Just left digicam control for a few minutes and it did eventually shut down properly... so just need to be patient.