Esper TriggerBox Multi Cam control

Use this forum to request new features or suggest modifications to existing features
Post Reply
Posts: 1
Joined: Fri Jul 12, 2019 1:24 am

Esper TriggerBox Multi Cam control

Post by kampgrizzly » Fri Jul 12, 2019 1:31 am

Maybe the following can be accomplished with the MultiCamera USB Relay settings, but I was having no luck.

I recently purchase an Esper Triggerbox camera controller for multi cam shutter release. Its a sweet unit. ... riggerbox/

The serial control protocols are straight forward and are outlined here
and ... mand-modes
and ... mands-list

Is there a way with the existing software to control this module?

Esper TriggerBox Multi Cam control


Duka Istvan
Posts: 684
Joined: Sat Oct 03, 2015 7:57 pm

Re: Esper TriggerBox Multi Cam control

Post by Duka Istvan » Wed Jul 17, 2019 7:12 am

You can use Arduino plugin to try to control this device

Posts: 3
Joined: Mon Apr 06, 2020 3:00 am

Re: Esper TriggerBox Multi Cam control

Post by dmcman73 » Mon Apr 06, 2020 3:24 am

I am also trying to get the ESPER Trigger box working as well. The serial baud rate for these boxes is 115200 8,n,1. I believe the baud rate programmed into digicamcontrol is set to 9600.
Is there a way that the baud serial port can be programmed inside of the settings of dgicamcontrol instead of having it hard coded?

It would be nice to develop plugin for the ESPER trigger box to program it's Focus and Shutter output, like something that this program from them performs (but "watered" down): ... x-software. In this program folder, there is a full set of serial commands for the box itself.

Set focus on the box (once all ports have been programmed) with a command of "F1" over the serial port

For the shutter release, it is simply "S" over the serial port

To disengage focus it is "F1"

Is it possible to create a plugin like this? If this isn't in your scope, is there any documentation in creating a plugin that I could add to the program?

Thank you,

Site Admin
Posts: 152
Joined: Tue Sep 15, 2015 8:33 pm

Re: Esper TriggerBox Multi Cam control

Post by admin » Mon Apr 06, 2020 10:59 am

Hi, you can use Arduino plugin for this propose, the plugin do same thing send data to serial port

Posts: 3
Joined: Mon Apr 06, 2020 3:00 am

Re: Esper TriggerBox Multi Cam control

Post by dmcman73 » Mon Apr 06, 2020 2:16 pm

Ive been scouring the documents for this and could not find any information on how to set the Arduino plugin up. I went through the source code and found that the water droplet plugin, that uses arduino, is hard coded to 9600 baud.

I added the Arduino device and in that section, there is no way to specify a baud rate, just com port and two shutter release options.

In the plugins, there is just Onscreen buttons to program functions to send but no baud rate.

Do I just set the baud rate of the port directly in the device manager in windows? I tried that with still no luck.

Thank you!

Posts: 4
Joined: Thu Jan 21, 2021 12:04 am


Post by Joshuaveift » Sun Feb 14, 2021 12:41 am

REMOTE CONTROL is on the list, but right now QTAKE SERVER has a priority.
BTW, you can use VNC client for iPad to control QTAKE remotely...


Post Reply