Page 1 of 1

Esper TriggerBox Multi Cam control

Posted: Fri Jul 12, 2019 1:31 am
by kampgrizzly
Maybe the following can be accomplished with the MultiCamera USB Relay settings, but I was having no luck.

I recently purchase an Esper Triggerbox camera controller for multi cam shutter release. Its a sweet unit.
https://www.esperhq.com/product/multipl ... riggerbox/

The serial control protocols are straight forward and are outlined here
https://support.esperhq.com/article/61-set-up-procedure
and
https://support.esperhq.com/article/63- ... mand-modes
and
https://support.esperhq.com/article/64- ... mands-list

Is there a way with the existing software to control this module?

Re: Esper TriggerBox Multi Cam control

Posted: Wed Jul 17, 2019 7:12 am
by Duka Istvan
You can use Arduino plugin to try to control this device http://digicamcontrol.com/blog/news_2.0.45