Unlike Nikon, Canon's default Transfer mode seems to be [1.Save to PC only]??
If I change it to [3. Save to PC and camera], of course it does work well.
But I turn off and again turn on Canon...it eventually returns to [1. Save to PC only]
https://youtu.be/97KYoG5ZrTA
How can I save Canon Transfer mode to [3. Save to PC and camera] ??
Thanks in advance.
[PS] Option check [File->Settings->Advanced->Load Canon transfer mode] is NOT solution in this case.
Canon Transfer Mode ??
Canon Transfer Mode ??
Last edited by kimys on Wed Dec 20, 2017 9:29 am, edited 1 time in total.
-
- Posts: 684
- Joined: Sat Oct 03, 2015 7:57 pm
Re: Canon Transfer Mode ??
Which version of the application do you use ?
Re: Canon Transfer Mode ??
It is ver. 2.0.74
Nikon remembers the last used transfer option 1 or option 3.
However, for Canon, the transfer option always returns to 1. when I turn the power back on.
I hope Canon will be the same way as Nikon.
Nikon remembers the last used transfer option 1 or option 3.
However, for Canon, the transfer option always returns to 1. when I turn the power back on.
I hope Canon will be the same way as Nikon.
Re: Canon Transfer Mode ??
Oh~~It works perfectly in version 2.0.72.
Thank you.
Thank you.
Re: Canon Transfer Mode ??
hi, im just starting to use digicamcontrol and loving it!. but i also have the same issue, using last beta version (.79) with a canon 80D, is goes to "PC only" after reconnecting the camera.
using the older version as mentioned (2.0.72) the setting is saved correctly after reconnecting.
thanks!
using the older version as mentioned (2.0.72) the setting is saved correctly after reconnecting.
thanks!
-
- Posts: 684
- Joined: Sat Oct 03, 2015 7:57 pm
Re: Canon Transfer Mode ??
You have a option for this File=>Settings=>Advanced=>Load canon transfer mode
Re: Canon Transfer Mode ??
Hi~~Duka
Checking the option "Load Canon transfer mode" does work normal ONLY in Ver 2.0.72
Checking the option "Load Canon transfer mode" does work normal ONLY in Ver 2.0.72