Help with current ICstation USB relay board

Support and help for digiCamControl (no bug report)
Post Reply
malcolmwill
Posts: 1
Joined: Wed May 30, 2018 11:37 pm

Help with current ICstation USB relay board

Post by malcolmwill » Thu May 31, 2018 5:09 pm

We're using digiCamControl to operate a 16-camera array (Nikon D3300) and intended to use an external trigger, through a USB relay, to operate the cameras. As the 2-relay board no longer seems to be available from ICstation, we purchased the 4-relay board (http://www.icstation.com/icstation-micr ... -4012.html). After rolling back the driver for the board to make it work with Windows 10 (it operates properly with the sample RelayBoardManager app downloadable from ICstation), I tried configuring the "Device" in digiCamControl per the blog entries: 5100 for initialization, then 0F for on and 00 for off (for 4-relay module). I also tried 03 and 00, as instructed for the original 2-relay board. Neither seems to have any effect on the board when I try to use the configuration in either Multi-Camera mode or for a single camera. Any suggestions? We're currently using the "RelayBoardManager" app from ICstation to trigger the cameras through the relay board. Thanks very much,
-Malcolm

Help with current ICstation USB relay board

Advertisment
 

Duka Istvan
Posts: 619
Joined: Sat Oct 03, 2015 7:57 pm

Re: Help with current ICstation USB relay board

Post by Duka Istvan » Sat Jun 02, 2018 11:49 am

Please send your log file Menu->Help->Send log file


Post Reply

Who is online

Users browsing this forum: No registered users and 4 guests