Report bugs and errors to the digiCamControl development team.
1 post • Page 1 of 1
Hello. I just purchased a new NIKON B500. I downloaded the digicamcontrol software and when I plug my camera into the computer the screen on the camera goes blank. The Digi cam sees the camera and notes its model. But there is no view on the screen and when I push the capture button the error code "Unknown error code 2147754003' pops up. About a minute later the camera takes a picture? ANy thoughts? I have reloaded digicam 2X and restarted the computer.
Error Code 2147754003
Who is online
Users browsing this forum: No registered users and 1 guest