CameraControlCmd crash
Posted: Fri Mar 01, 2024 7:23 am
I am testing digicamControl for it's scripting capability, i want to write a small scirpt for the upcoming solar eclipse.
i used the digicamControl GUI and it work perfectly, then closed the software as requested and lunched CameraControlCmd, the window closes after any commands, even the help command or a simple 'enter' close the window (i am assuming it's crashing). I observed the same behavior with CameraControlRemoteCmd
Any suggestion/help will be greatly appreciated !
Thank you
Francois
PS: I uninstalled and reinstalled digicamControl, but it did not help
i used the digicamControl GUI and it work perfectly, then closed the software as requested and lunched CameraControlCmd, the window closes after any commands, even the help command or a simple 'enter' close the window (i am assuming it's crashing). I observed the same behavior with CameraControlRemoteCmd
Any suggestion/help will be greatly appreciated !
Thank you
Francois
PS: I uninstalled and reinstalled digicamControl, but it did not help